|
|
|
These process trainers can be customized to any requirements such as process
specific equipment needs for training such as designated brands of components,
off site supervisory control and newer technologies such as Field Bus
capability.
 
(Click thumbnails for larger image.)
BTTC-BIT
- Basic Instrument Trainer
- Standard Model
- Custom Model
Built to allow hands on training, the BIT consists
of two tanks, a level column, magnetic drive pump and three control loops.
The control loops are for level, flow and pressure control. Operating ranges
are of level. The standard unit comes with one pneumatic loop, and two conventional
electronic loops. The pneumatic loop can control either the flow or the
level. The pressure control loop is a split range set-up. The two tanks
are for two liquids of different specific gravities.
BTTC-CPT Custom Process Trainer
|
The
BTTC Process Trainers are “hands on” training units
for process operators and maintenance technicians. The units are
built to duplicate “real world” operating equipment
and consists of separate functions all integrated into a compact,
effective training unit in order to train personnel in the process
industry in a safe manner. The units consists of the following component
sections:
(A) Pumps – There are two ANSI process
pumps mounted in parallel on the trainer.
(B)Tanks & Piping – The trainer is equipped with two tanks
and associated interconnecting piping. All tanks and piping are
stainless steel to minimize corrosion.
(C) Level Control – The BTTC Process Trainer is equipped with
a level control loop, which controls the level in the top receiver.
(D) Pressure Control – The unit is equipped with a pressure
control loop.
(E) Flow Control – The trainer has an orifice flow control
loop on it. The flow is controlled to the overhead tank.
(F) Temperature Control – A temperature control system/loop
is provided with the trainer. The system consists of a side stream,
which flows through a fixed wattage heater. For safety reasons,
the heating unit is equipped with a high temperature shutdown and
an over pressure relief valve.
(G) PLC – The Programmable Logic Controller (PLC) is an Allen-Bradley
SLC-50. It is integrated to all the control loop functions of the
trainer. As received, it is programmed to operate the system, as
well as provide cascading abilities between various loops. If desired,
it can also be equipped and programmed to provide supervisory interlock
functions. |
BTTC-EPT Educational Process Trainer
(Click thumbnails for larger image.)
|
| The Process trainers
are capable of a minimum of 38 specific training and educational functions
with an endless number of potential variables for trouble shooting
scenarios on piping, valves, flanges, flow, level, pressure, electrical,
instrument, pneumatics, ---------------It is endless what can be taught
on this all around trainer. |
|
|
