HECT-2 U-Tube Circulation Trainer
Specification & Sizes:

U-Tube Acrylic Heat Exchanger	8”
Tubes	1/2”
Length	32”

This table top working model has two (2) circulation pumps and two (2) supply tanks for demonstration. Different colored water streams will be circulated through the shell side and through the tube side to simulate the working of a real heat exchanger.

CT-1 Acrylic Cooling Tower

Dimensions:

32” x 27-1/2” x 30”

Oil Refineries and Petrochemical plants use water to cool down the high temperatures that are generated by the particular process they use. This model is made of acrylic to allow full view of the water flow through the tower. This table top working model has an induction fan, circulation pump and tank.

PDTM-2 Pump Demonstration Working Model

This “see through” training model has many features that can be used to train operators on the mechanical workings of a centrifugal pump. By manipulating the flow with suction and discharge valves and adjusting RPM’s this model can demonstrate cavitation and other pump and flow phenomena. Our Pump Demonstration Model is a very popular tool for a site and sound concept of these workings, which cannot be experienced in the field or with drawings or computer simulations.

TPS-2 Three Phase Separator

BTTC has designed and built the TPS-2 Three Phase Separator to simulate process specific phenomena associated with the separation of gasses and fluids typically found in a crude oil production stream. This process trainer is a self contained unit which continuously mixes air, water, and a hydrocarbon based fluid which then flows into a series of ‘see through’ vessels where gravity separation takes place. The liquid components are returned to individual storage tanks prior to reblending, and the air is discharged to atmosphere. The trainer is equipped with process measurement devices and is operated from an integral control panel.

EQUIPMENT SPECIFICATIONS:

• Entire unit mounted on metal structure with casters
• Two pumps for oil and water
• Air compressor
• Acrylic separation vessels
• Oil and water storage tanks
• Inline mixer and aerator to blend gas and fluids
• Electronic flow, level, and pressure control devices
• All metallic non-moving surfaces powder coated for durability and corrosion prevention
• Operates on 240 volt single phase power
• Approximate overall dimensions: 34” wide X 84” long X 72” high

ABM Acrylic Boiler Model

Dimensions:

39” x 22” x 42”

This working model of a boiler consists of 32 water tubes, mud & steam drum, reservoir, mud drum, and blow down valves. Interactive boiler feed water pump and overflow valves are included. An impressive flow and dynamic visual make this see thru model a training asset.

DTU-4 Acrylic Distillation Tower

Dimensions:

(Packed Column)

Height:	90"
Diameter:	8"

At 7 and ½ Feet tall this working model is an impressive and dynamic educational piece of equipment!

It dramatically demonstrates the operation of a column using water and air. The models simulation is designed to show the basic process of distillation. Liquid traveling downward comes in contact with the vapors (gas bubbles) traveling upward, thus allowing the cooler liquid to condense any heavy compounds out of the lighter vapor stream.

LUBE Lubrication Training Unit
(click image for larger picture)

The Lubrication trainer is an acrylic bearing housing showing three of the most common methods of using a static pool (reservoir) to lubricate bearings. The unit is equipped with a variable speed motor, which allows the shaft to run slowly and at operating speeds. This allows the student to observe the lubrication process as well as rotating equipment such as the shaft and coupling.

CODTM Crude Oil Desalter Training Model

Dimensions:

Height:	32”
Length:	36”
Vessel	35” x 8"